|
|
 |
Introduction |
|
How The System Works |
|
Technology |
 |
Features |
|
Specifications |
 |
Manufacturing |
|
Product Sheets |
|
CO Poisoning |
|
Alarm Service Panel Interface UltraGuard can be used as a stand-alone system or communicate with an Alarm Panel. Each of the four zones has an independent set of contacts. A single set of fault contacts reports a fault condition in any zone. The Alarm Company receives information about both the type of problem and the location of an alarm in the residence.
|
||||
Seven Indicator Lights The Front Panel Lights reflect the status of each function: Alarms, Sensors’ integrity and life span, low temperature condition. A problem or fault activates Trouble Light and affected Zone lights blink. Light remains ON to indicate fault type until the problem is corrected.
|
||||
Unique Bio-Mimetic CO Sensors UltraGuard uses the most advanced and reliable technology available today. Our Sensors imitate the human body's absorption of CO with 99% accuracy, as tested by the Lawrence Berkeley Laboratory.
|
||||
Automatic Furnace Shutdown / Restart When the Control Unit receives a dangerous CO concentration signal, a relay shuts down the connected furnace, the source of 95% of CO Gas accidents. The system allows the furnace to restart automatically when CO dissipates.
|
||||
Multiple CO Detector Inputs/Stackable The Control Unit has inputs for four zones and up to 7 Detectors, allowing reliable individual monitoring of each designated zone with up to five sensors per zone. Each of the four zones communicates with a relay unique to that zone and, in the case of a fault, a common relay communicates the condition to the Alarm Panel. Units can be stacked, gaining additional 3 zones per each additionally stacked unit.
|
||||
Siren (Sounder) In Alarm Mode both the Control Unit and each affected CO Detector sound siren. In the Trouble mode, the sensor emits a chirping sound every thirty seconds and the Control Unit once a second until reset button is pushed.
|
||||
Sensor Replacement Clock An internal five-year clock alerts when a sensor expiration date nears. The clock is reset when sensors are replaced.
|
||||
Addressable Sensor Relays UltraGuard CO Sensors are configured to communicate alarms and faults to Control Unit and, if connected, Alarm Panel.
|
||||
Internal Self-Test Each CO Detector performs an automatic internal self-test every ten minutes for proper operation. A problem or fault activates the Trouble Light on the Control Unit.
|
||||
Internal Temperature Sensor If the temperature drops below 45°F due to furnace failure UltraGuard triggers a chirping signal and transmits the information to Alarm Panel.
|
||||
Easy Installation The Control Unit is easily installed via “snap-in” connectors. No jumpers required for unused zones.
|
||||